Thingiverse
Quest 3 Facial Tracker Mount (Micro)
von T1MAT1C
5
Downloads
23
Likes
1
Makes
NO GLUE
Recommended maximum accuracy of your 3D printer (I printed at 0.08mm)
If the regular version didn't work for you, try the thickened version (PETG / 0.2mm layer) [Photos by teflon.1104]
This is a new version of the mount designed from the ground up
The previous version got a lot of likes and motivated me to do something better.
Meet the Micro Mount!
Post make if it works for you (^///^)
Recommended maximum accuracy of your 3D printer (I printed at 0.08mm)
If the regular version didn't work for you, try the thickened version (PETG / 0.2mm layer) [Photos by teflon.1104]
This is a new version of the mount designed from the ground up
The previous version got a lot of likes and motivated me to do something better.
Meet the Micro Mount!
Post make if it works for you (^///^)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!