Quest Pro Ear Cups

Quest Pro combined ear cups and top strap mount.

Designed to fit the Studioform strap, but others should work, too.

The ear cups increase the sound volume quite significantly. Before the mod it was always too low, now it is borderline uncomfortable at 100%. I now run it at 80% an still have some headroom.

There is also a cable tunnel on the left part which can be used to route an USB cable (link cable/battery) either to the top or to the back.

Parts should print fine without any supports. Depending on the printer a brim might be required.

When the parts are attached they slight easily back and forth. If you don't want that, just add a Tesa Powerstrip or something to the inner side - you don't need to remove the protective layer from the strap on the headset side.
It doesn't need to be glued in place, we just want the additional thickness!