Quest Pro front rear strap system

With this mod for the Meta Quest Pro you will be able to include a buckle in the front part to later add a front-rear strap system.

To do this you will also have to remove the back part (just pull it carefully so that it comes out) and place an adhesive Velcro in the center.

In this way the strap should have a Velcro system to hold it at that point and through the buckle on the front.

Once printed, you will also have to disassemble the front part and the rear trim carefully remove it. The two central anchors are left over, so you will have to cut them and replace them with the buckle.

Subsequently, the trim would be placed again by pressing. The trim will be a little deformed because of this but it will keep all its ergonomic and aesthetic options.

I used the strap from the top of a KIWI Quest 2 attachment system, but you can use any strap with a maximum width of 30mm.

The system is designed to be as "pretty" as possible and not to spoil the design of Quest Pro while