Quest Q40 Wall Hanger

Recently acquired a Quest Q40 metal detector and because of the shaft design and how quickly you can compress the shaft and the space it needs, I decided it needed a wall hanger. But there was nothing available. I looked for other design ideas and decided that I could work with the CTX3030 hanger as a starting point.

This has been extrapolated out to have a beefy mount and reach around the center DD cross bar. It is a snuggish fit so the coil/detector can't move left and right very easily while hanging.

When printing I chose to lay it flat as shown so the layers give strength rather than vertical. I use a FF Dreamer and printed at standard quality ABS, but changed the perimeter to 3, the fill type to 3d and the percentage to 50%. It took a bit over 2 hours for this little part but I didn't want it to fail and drop the detector from the wall.

Also, even thought there are guide holes for screws, you should pre-drill to the size you are using so that it does not cause the pr