Quick-Access Magnetic Toolhead Interface – H2S

If you frequently swap nozzles on your H2S printer, or just doing maintenance, you know how frustrating the original toolhead cover can be. The stock design relies on small snap clips that are fragile, annoying to remove, and easy to damage over time.This magnetic interface plate replaces the clip-based connection between the toolhead and the toolhead cover, allowing quick, tool-free access to the hotend while keeping the original clips protected from wear and breakage.Simply pull off the cover when needed, access the hotend, and snap it back into place magnetically, no fighting clips or risking broken parts.Used hardware:2 x D6x3mm round magnets2 x D4x2mm round magnetsDepending on what filaments you print, I would recommend printing this model with PETG or any filament that is more heat resistant, as with PLA you would risk deformation over time caused by the heat of the printer.I printed the model with a transparent light blue PETG filament from BambuLab, but if you print it with the