Quick Backlash Calibration V.2

Introduction.
----------------
This is a method for quickly getting a good backlash calibration on your 3D printer.
You just zero out the backlash compensation in the software. Then print the objects, Read the correct value and enter it as your new backlash compensation and be done with it.

The files have been created with the M3D Micro in mind but should work for all 3D printers of the Cartesian type. It will not work for delta printers.

Instruction.
--------------
Before getting started on this, you need to make sure your print bed is clean and very well
calibrated. The print is just a single layer and it needs to be printed just right across the entire surface. You can find more information about bed leveling below.

Before starting the first print make sure to set backlash compensation to zero. Make a note of the old values in case you need to go back.
Watch the print start and remove the extra filament that is extruded in the beginning. It is just to prime the no