Thingiverse
Quick change filament holder
von Masterjayon
1
Downloads
1
Likes
0
Makes
buy preassembled at :
https://www.etsy.com/Godof3dprinting/listing/1183362872/magnetic-filament-holder?utm_source=Copy&utm_medium=ListingManager&utm_campaign=Share&utm_term=so.lmsm&share_time=1647443176637
I saw the tons of filament holders on here but none kept a low profile and worked perfectly for me. So I did what I always do create my own solution. So here's my quick change filament holder
fits Ender 3 v2 and other similar x-axis
Print warnings
*Neodymium magnets are strong and fragile*
make sure the magnets attract properly before gluing
Supports are needed only for the stand
The holder requires bridging
If your printer isn't good at bridging
Print horizontally on a raft
Try to remove any big Imperfections
if you want to take it out of that spool later
bearings are a little tight putting on but work well after assembled
The bearings can be used independently from the holder (and vice versa)
bearing less model coming soon
https://www.etsy.com/Godof3dprinting/listing/1183362872/magnetic-filament-holder?utm_source=Copy&utm_medium=ListingManager&utm_campaign=Share&utm_term=so.lmsm&share_time=1647443176637
I saw the tons of filament holders on here but none kept a low profile and worked perfectly for me. So I did what I always do create my own solution. So here's my quick change filament holder
fits Ender 3 v2 and other similar x-axis
Print warnings
*Neodymium magnets are strong and fragile*
make sure the magnets attract properly before gluing
Supports are needed only for the stand
The holder requires bridging
If your printer isn't good at bridging
Print horizontally on a raft
Try to remove any big Imperfections
if you want to take it out of that spool later
bearings are a little tight putting on but work well after assembled
The bearings can be used independently from the holder (and vice versa)
bearing less model coming soon
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!