quick clamp mug holder

A mug holder with a quick clamp system. What is new? the quick clamp system, providing a very strong hold of the clamp on the table. Print in ‘strength’ profile, I used PETG but PLA could work. Print with supports. Assembly: use a M6 40mm screw to connect the trigger. Check the side on the picture. slide the moving jaw into the vertical shaft. The insert the mug holder in the joint. To fix it on the table: slide the moving jaw up, press strongly, turn the trigger. Voila. If the fix is not strong enough: open the trigger, slide the jaw up by one click, close the trigger