Thingiverse
Quick Grip corner pads
por telekineticyeti
461
Descargas
301
Likes
5
Makes
These are replacement pads for quick-grip tools that allow you to use your clamp to hold two pieces of material at a 90 degree angle.
These pads are designed to fit standard quick-grip clamps from the Irwin brand, but may fit others.
One side of the clamp interface is open, allowing you to slide the grip into place. Static friction should keep the pad in place, dependent on your printer tolerances. If the pad slips or is difficult to slide on, try heating the pad gently with a heat gun or adjusting the size of the print to suit your printer's tolerances.
These pads are designed to fit standard quick-grip clamps from the Irwin brand, but may fit others.
One side of the clamp interface is open, allowing you to slide the grip into place. Static friction should keep the pad in place, dependent on your printer tolerances. If the pad slips or is difficult to slide on, try heating the pad gently with a heat gun or adjusting the size of the print to suit your printer's tolerances.
telekineticyeti también publica en
2 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
