MakerWorld
3D Printer Parts
Ver Modelo
Quick Low Profile AMS LED Riser + Venting Profile
2.1k
Descargas
803
Likes
1.3k
Makes
This is a easy and quick printable AMS riser for adding LEDs to your printer. The LEDs I used are 8mm 5v COB LEDs with a usb connector plugged into the free usb slot on the P1S. Total print time is 3.5 Hours for two plates no supports needed. Printed in sports mode with esun PLA without any issues. If you have an issue with the width and length being too long, swap the corners.Check the slicer to see which corner goes with which side, they are labelled; FR=Front RightFL=Front LeftBR=Back RightBL=Back Left Link to LEDs used: https://amzn.eu/d/0b8H7T6A The top glass used on the X1/P1 series are the same so this should fit both.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
