Thingiverse
Quick Mask (Vase mode)
par jagoosw
4
Téléchargements
2
Likes
0
Makes
This mask was designed for quick printing so that it is easy to make and share with anyone in need in your community. It is not intended for health care professionals and if worn for a long time is likely to cause discomfort.
The mask is simple to construct only requiring an appropriately sized piece of fabric (~10cm diameter circle) and some elastic. Holes need to be stabbed in the flanges on the retainer for the elastic and it may be a good idea to glue the fabric to the retainer and then to the mask.
For some guidance on material choices this paper I wrote may be helpful: https://www.preprints.org/manuscript/202006.0132/v1 I have been using pieces of a H13/H14 bag type filter.
For thicker materials the retainer may need to be scaled up slightly.
It is most comfortable to print this mask out of polypropylene but is quite hard to get right, experimentation being required with the layer height and speed to get the layers to adhere and not collapse. Otherwise it can be prin
The mask is simple to construct only requiring an appropriately sized piece of fabric (~10cm diameter circle) and some elastic. Holes need to be stabbed in the flanges on the retainer for the elastic and it may be a good idea to glue the fabric to the retainer and then to the mask.
For some guidance on material choices this paper I wrote may be helpful: https://www.preprints.org/manuscript/202006.0132/v1 I have been using pieces of a H13/H14 bag type filter.
For thicker materials the retainer may need to be scaled up slightly.
It is most comfortable to print this mask out of polypropylene but is quite hard to get right, experimentation being required with the layer height and speed to get the layers to adhere and not collapse. Otherwise it can be prin
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !