Slicer Discord
Quick Release Camera Strap Adapter  – 3D-Druckmodell von MakerWorld MakerWorld
Electronics

Quick Release Camera Strap Adapter

559 Downloads
385 Likes
367 Makes
Zum Modell
This is a quick release anchor and strap attachment that is obviously inspired by the Peak Design System. It works similarly, with a spring locking the anchor in place until you press down on the anchor and pull it out to release it. DISCLAIMER: I have not load tested this! It's strong and I've had no issues, but it will vary based on material, print settings, cordage, etc. Please ensure yours is strong enough to support the force of your camera falling before you put too much trust in it! Here's how it goes together: Print the parts. The Anchor with supports is pre-supported and has a little tab that you can pull on to remove the support piece. Use micro cord or paracord (or whatever you want, I guess) and make a loop about 4 inches long (8 inch circumference). For paracord, I just melt the ends together. A knot will not fitPlace the cord loop into the anchor base with the know in the largest part of the cavity Apply some super glue to the top faces of the basePut on the t
Kategorie
Electronics
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
Supports nötig
Einteilig Supports nötig
Supports 2/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Kleben
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen