Quick release nut for cymbal
door bencina
323
Downloads
218
Likes
1
Makes
This is quick release for cymbal or something else.
It is made for two metric threads M6 and M8.
The M6 has two identical pieces for the casing.
The M8 has a smaller pin, so the casing is made of two different pieces.
I printed with ABS material and assembled with acetone.
You could also stick with glue.
In the middle there is a small spring that you need to get and insert. In the picture is only marked with a pencil.
05.12.2017
On request, I added an option where the housing is screwed with a small countersunk wooden screw with a diameter of 2mm.
12.03.2019
On request, I added M10 and M12 fast nut. But I did not print so could somebody prints and tells me if it's OK.
It is made for two metric threads M6 and M8.
The M6 has two identical pieces for the casing.
The M8 has a smaller pin, so the casing is made of two different pieces.
I printed with ABS material and assembled with acetone.
You could also stick with glue.
In the middle there is a small spring that you need to get and insert. In the picture is only marked with a pencil.
05.12.2017
On request, I added an option where the housing is screwed with a small countersunk wooden screw with a diameter of 2mm.
12.03.2019
On request, I added M10 and M12 fast nut. But I did not print so could somebody prints and tells me if it's OK.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!