Quick tool Change Base V5 with Servo Mount

Remix of ProperPrintings Tool Change setup, https://www.thingiverse.com/thing:3369444

X and Y Probe Offsets should be the same as mine. Of course it might be with the Z-offset, but my setting should be close:
X is -50.0
Y is +20
Z is -5.77

I Made a change to accommodate a 9 gram servo for Auto Bed Levelling. The arm is included. I used the Z-Stop probe switch. I removed it from the board it was soldered to. I removed the metal tab from the switch. I used the screws that hold it to the board to mount it to the arm. The arm is made from 2 parts, https://www.thingiverse.com/thing:3664819 from Karip for the servo end of the arm, and the lower end from https://www.thingiverse.com/thing:3293821 by terenceang. It left a small area to bend the pins down of the endstop switch after soldering the wires to it.

To use the servo probe on the Creality 4.2.2 or 4.2.7 boards I used the description from terenceang's "Under $10 DIY Auto Bed leveling Z-Probe for Creality Ender 3", and realiz