Thingiverse
QuickClick compatible unicycle saddle mount
by mowcius
0
Downloads
1
Likes
0
Makes
This is a Topeak QuickClick compatible mount designed for KH and DDK unicycle bases.
The specific bag you use and the angle of your seat will affect the fit, but this has been designed to be as compatible as possible without any major compromises.
It should be compatible with all of the following bags from Topeak:
Sidekick Wedge Pack
Wedge Pack II
Aero Wedge Pack
Aero Wedge Pack DX
Shown above on a DDK base.
Ensure you print this at 100% infill or the saddle bolts will crush the hollow sections.
Print with the flat side down on the bed, and the "arrow" facing upwards. The orientation is not correct straight from the STL. No supports are required.
If you want to use bags with velcro straps rather than QuickClick, check out this model:
https://www.thingiverse.com/thing:4932460
The specific bag you use and the angle of your seat will affect the fit, but this has been designed to be as compatible as possible without any major compromises.
It should be compatible with all of the following bags from Topeak:
Sidekick Wedge Pack
Wedge Pack II
Aero Wedge Pack
Aero Wedge Pack DX
Shown above on a DDK base.
Ensure you print this at 100% infill or the saddle bolts will crush the hollow sections.
Print with the flat side down on the bed, and the "arrow" facing upwards. The orientation is not correct straight from the STL. No supports are required.
If you want to use bags with velcro straps rather than QuickClick, check out this model:
https://www.thingiverse.com/thing:4932460
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!