Thingiverse
QuinLED Dig-UNO Bases
von SynApps
54
Downloads
17
Likes
0
Makes
This is my version of a mount for the QuinLED Dig-Uno Boards.
I made it using Tinkercad and have multiple versions because I could not make up my mind.
I printed them in PLA and have had those 2 mounted outside in a CG1500 box in South Florida with no issues.
Most are designed with a friction fit in mind. A bit of hot glue could help if it's too loose for you. I insert the board by sliding into the overhangs and then let the small circles hold it with friction.
One of the flat version has holes, but I have not tested it. Feel free to remix and improve upon them, I'm just not very good at CAD.
I made it using Tinkercad and have multiple versions because I could not make up my mind.
I printed them in PLA and have had those 2 mounted outside in a CG1500 box in South Florida with no issues.
Most are designed with a friction fit in mind. A bit of hot glue could help if it's too loose for you. I insert the board by sliding into the overhangs and then let the small circles hold it with friction.
One of the flat version has holes, but I have not tested it. Feel free to remix and improve upon them, I'm just not very good at CAD.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!