Qwik Weld and multipurpose System

The main reason I created this project is that I had a lot of T-slot rails, and I bought a flux core welder, so I wanted to get started on welding round tubing. In the typical fashion of a solution looking for a problem, I designed a series of welding jigs that I could use in many different situations. Also it was designed for flexibility in mind of different types of tubing.


Features
*Can be used on a variety of different sizes and shapes of tubing as long as it's between .50 to 1.5 inches in diameter. (reference pic for sketch that allows diametrt change)
*Top side Bracket Allows a whole range of ways to set up 20x20 T-Slot railing.
*L Brack is a beefier bracket ideal bracket for higher loads placed on the t-slot rail.
*Center is used for short tubing.
*Angle Bracket allows for tubing to be angled up to 45 degrees
*T slot rail angle bracket allows rail to be angled (reference pic for sketch that allows angle change)

Parts
Each tube clamp assembly consists of
Qty 2 M5x8mm bolt