Thingiverse
R/C Mini Boat Stand
by jhetland
3
Downloads
2
Likes
0
Makes
I was looking for a stand I could use to display an [Adventure Force Mini Boat](https://www.walmart.com/ip/Adventure-Force-Radio-Controlled-Mini-Boat-Green/410180387) we picked up from Walmart on clearance for $7.
I found [https://www.thingiverse.com/thing:2543397](https://www.thingiverse.com/thing:2543397) which included a stand but it had a lot more bulk than i wanted so i used its rought dimentions as a starting point for my own take on the stand.
To create the stand you will need:
* 2x Frames
* 6x Rods
On my printer with 0.12 resolution, the rods fit nice and snug into the openings, I used a small needle-nose pliers to push the rods down into the upper openings.
_(I'm intending to try and add a hobby-grade receiver to these as a future project, and possibly try adding micro brushless motors as well)_
I found [https://www.thingiverse.com/thing:2543397](https://www.thingiverse.com/thing:2543397) which included a stand but it had a lot more bulk than i wanted so i used its rought dimentions as a starting point for my own take on the stand.
To create the stand you will need:
* 2x Frames
* 6x Rods
On my printer with 0.12 resolution, the rods fit nice and snug into the openings, I used a small needle-nose pliers to push the rods down into the upper openings.
_(I'm intending to try and add a hobby-grade receiver to these as a future project, and possibly try adding micro brushless motors as well)_
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
