R-XSR Hard Case

This is a hard case for the R-XSR for situations where you want more mechanical robustness. For example, a larger RC plane or helicopter.

The design mechanically secures both the picoblade connector and the antennas while providing 2 secured servo connectors.

In the diagrams, note the burgundy-colored 1.5mm foam padding. This is needed to hold the R-XSR and antennas in place without crushing any components. The foam pad over the picoblade connector is intended to keep it plugged by form-fitting over the connection.

The pins are 2.54 mm double row right angle connectors. These are soldered to a perf board and then to the pico blade connector. You'll want to choose one side or the other and solder the two ground pins together (I suggest the side that aligns with the ground pin on the picoblade). The middle pins are for VDD, you'll generally want to solder these together as well. The remaining two pins are for whatever you want. Generally, you would use one of these f