R106 5G CPE shell

This is a 3D printed case for R106. Has both active and passive cooling mode. And you can also swap the antennas if you like.
To build this ,you need:
Four M2*14 screws
Two M2*6 screws
Six M2 nuts
Three 28*28*3mm heat sinks
One 3007 turbine
One SS-12F15 G5 switch
Three 5cm welded to SMA female (note that the line should be selected with a wire diameter of 1.13 ）
Three 10cm welded to SMA female (note that the line should be selected with a wire diameter of 1.13 ）
(Pay attention to the inner pin or inner hole of SMA, I personally choose the female inner hole and the inner pin antenna)

(Actually, you can also choose to use six 10cm welded to SMA, that would made the cable management process a lot easier)