Thingiverse
Rabbit R1 Mockup
door Mauronic
1
Downloads
5
Likes
1
Makes
Here's the Rabbit R1 mockup featured in this build video: https://www.tiktok.com/@petemeets/video/7327116503709486379
- Arrange the parts according to the screen shot and use support material where needed
- I printed with 0.30 PLA in draft mode
- Other settings may impact the snap-fit aspect of the screen
- You need to glue the back, future version may be snap-fit or support screws
- Actual 100g weight was achieved by adding dummy weight inside. I hot glued washers to the back of the screen
- I used a printed R1 screen with the rabbit logo and a glue stick to mock up the screen. It looks realistic on video and in pictures, just not so great on the close ups
Let me know if you have any questions. If you are a Rabbit R1 fan, you can thank me by following my TikTok series on the device 👍🏼
- Arrange the parts according to the screen shot and use support material where needed
- I printed with 0.30 PLA in draft mode
- Other settings may impact the snap-fit aspect of the screen
- You need to glue the back, future version may be snap-fit or support screws
- Actual 100g weight was achieved by adding dummy weight inside. I hot glued washers to the back of the screen
- I used a printed R1 screen with the rabbit logo and a glue stick to mock up the screen. It looks realistic on video and in pictures, just not so great on the close ups
Let me know if you have any questions. If you are a Rabbit R1 fan, you can thank me by following my TikTok series on the device 👍🏼
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!