Thingiverse
RaceFace Aeffect Crank Boot
von Sadkovvsky
7
Downloads
6
Likes
0
Makes
Made up for RaceFace Aeffect Crank for 2017 and older models.
Infill doesnt change anything due to width of model walls. part should slide in with no problems but is its too lose you can warm it up a little using a lighter and press it on every side.
Infill doesnt change anything due to width of model walls. part should slide in with no problems but is its too lose you can warm it up a little using a lighter and press it on every side.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
