Thingiverse
Racing Simulator Handbrake
von baffo
1
Downloads
1
Likes
0
Makes
Hello everyone this is my Racing Simulator handbrake.
You just need to print all pieces and mount it.
I used a 15.5mm metal tube (alluminium) as lever pin, and you need 4 m3 screws.
I used a generic Usb Joystick motherboard that you can buy on amazon or ebay ecc. for less than 15€ and one Endstop.
You just need to print all pieces and mount it.
I used a 15.5mm metal tube (alluminium) as lever pin, and you need 4 m3 screws.
I used a generic Usb Joystick motherboard that you can buy on amazon or ebay ecc. for less than 15€ and one Endstop.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!