Thingiverse
Racking Label Clip
von M3cael
2
Downloads
1
Likes
0
Makes
To help organise the racking where we store coffee, a clip to attached the the horizontal beams of our racking.
Two version one with a chamfer and one with filleting.
Also tested printing with the flat face down but this would require supports so would probably be best suited to printing on the side.
Not tested IRL yet.
Face is 130mm x 80mm
Two version one with a chamfer and one with filleting.
Also tested printing with the flat face down but this would require supports so would probably be best suited to printing on the side.
Not tested IRL yet.
Face is 130mm x 80mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!