Thingiverse
Radar Bucket
di RKilo
1
Download
1
Likes
0
Makes
Here is a 3D print of the 'radar bucket' to fit a Kustom Signals Falcon (or similar style hand held radar)
The first image is a real one, the one in the car is this 3D printed replica mounted.
The real ones were vacuum formed and then trimmed/cut with snips to fit any car/console, and holes were hand drilled wherever they were needed.
I've included two stl's, one like the real thing and one pre trimmed/drilled.
They usually get screwed to the side of the console or transmission tunnel.
Ive also included a template to print so you can cut a piece of rubber (or print it out of TPU) that sits inside to prevent scratching the lens.
If you are going to print the original one and trim it yourself, id recommend 100% infill.
I printed it out of ABS-GF for strength/heat resistance. No supports required if you are going to cover the inside with the rubber/TPU.
The first image is a real one, the one in the car is this 3D printed replica mounted.
The real ones were vacuum formed and then trimmed/cut with snips to fit any car/console, and holes were hand drilled wherever they were needed.
I've included two stl's, one like the real thing and one pre trimmed/drilled.
They usually get screwed to the side of the console or transmission tunnel.
Ive also included a template to print so you can cut a piece of rubber (or print it out of TPU) that sits inside to prevent scratching the lens.
If you are going to print the original one and trim it yourself, id recommend 100% infill.
I printed it out of ABS-GF for strength/heat resistance. No supports required if you are going to cover the inside with the rubber/TPU.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
