Thingiverse
Radiacode-101 case
por drezster
12
Descargas
11
Likes
0
Makes
Needed a quick and dirty case for my Radiacode and so why not share it.
Things to note:
This is a very basic enclosure, the two sides are held together mostly by luck and hope. One can add a tiniest drop of acetone (for PLA / ABS) or superglue to give it a better chance. Or some tape.
The enclosure is meant to protect against scratches, not dust, water or drops from height. I'd recommend keeping it in a grip lock bag anyway to prevent contamination.
Speaking of scratches - careful when fitting the top part over the dosimeter. The tabs might leave marks on the case because the Radiacode plastic quality is nothing to write home about.
The top part goes on first, then carefully attach the bottom case.
Might improve it in the future when needed.
Happy prospecting!
Things to note:
This is a very basic enclosure, the two sides are held together mostly by luck and hope. One can add a tiniest drop of acetone (for PLA / ABS) or superglue to give it a better chance. Or some tape.
The enclosure is meant to protect against scratches, not dust, water or drops from height. I'd recommend keeping it in a grip lock bag anyway to prevent contamination.
Speaking of scratches - careful when fitting the top part over the dosimeter. The tabs might leave marks on the case because the Radiacode plastic quality is nothing to write home about.
The top part goes on first, then carefully attach the bottom case.
Might improve it in the future when needed.
Happy prospecting!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!