Thingiverse
Radio Controlled (WWVB) Watch Tower
by iamaustin
0
Downloads
0
Likes
0
Makes
### ESP32 Watch Tower V2
=================
A Watch Tower using a ferrite rod antenna and an esp32 chip which synchronizes radio-controlled watch movements, like those found in g-shock and Junghans watches.
This STL is a remix of the watch tower from Mike Burton (https://github.com/emmby) split into two pieces to make inserting the electronics and antenna much easier. It also leads to a less sketchy print experience, as that model is recommended to print without supports.
***Settings:*** Print the base with supports, you'll likely not need to remove any of the supports except for along the back wall, where the external port is located.
##### The corresponding git repository can be found here: https://github.com/adotagarwal/WatchTower2/tree/main
=================
A Watch Tower using a ferrite rod antenna and an esp32 chip which synchronizes radio-controlled watch movements, like those found in g-shock and Junghans watches.
This STL is a remix of the watch tower from Mike Burton (https://github.com/emmby) split into two pieces to make inserting the electronics and antenna much easier. It also leads to a less sketchy print experience, as that model is recommended to print without supports.
***Settings:*** Print the base with supports, you'll likely not need to remove any of the supports except for along the back wall, where the external port is located.
##### The corresponding git repository can be found here: https://github.com/adotagarwal/WatchTower2/tree/main
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!