RadRunner Side Panels

These are side panels that I designed for the RadRunner, they come in two versions that can be mounted either using velcro straps or plastic clamps and M5 screws.

I used laser cut acrylic sheets but these can be cut from just about any sheet material. I've included SVG, STL, and SCAD files.

I've added an SVG that's simple line segments showing the raw panel dimensions I used without the rounded corners. Here are the raw dimensions:

Top: 342.9mm
Bottom: 214.33mm
Left 230.93mm
Right 226.01mm

**WARNING** I used 1 inch Nylon R-Type cable clamps with the screw mount design but I noticed that there is a lot of variability in what's considered a 1 inch clamp. I tried to make panels for a friend with clamps I purchased off Amazon and they were way too small.

Make sure your clamps have at least a 1 inch inner diameter otherwise they might not fit around the Radrunner frame or be too short to engage the panel.