Radxa Taco NAS case

NOTE: Apparently the thumbnails dont work on Thingiverse anymore. My apologies if you cant see the files or 3d models in the 'Thing Details' view. I can assure you, the parts are all there in the 'Thing Files'...

Fits the Radxa Taco board and 80mm PC fan with up to 5x 15mm HDDs

Requires:
80mm PC fan and screws - I used Arctic Temperature Controlled.
M2 hex bolts and heat set nuts - for Taco board
M3 hex bolts and heat set nuts - for all other fixings

Assembly:
Put in all the heat-set nuts
Fix CM4 module and heat sink to Taco board.
Attach Taco Board to 'Lid'
Attach HDD's/SSD's
Attach HDD/SSD caddy feet - check orientation!
Attach Fan to base.
Plug fan into 12v ATX pin. There's not much airflow, so the fan doesn't need to be full speed. Use a low noise adapter, or a temperature controlled fan.
Fit base over HDD's
Screw HDD caddy feet into base
Fix 'base' to 'lid'

I used long M3 bolts (with heat-set nuts) for 'feet' to raise the case up and get some air to the fa