Radxa Zero 3W/3E Case

A smooth and clean enclosure with hex ventilation holes for the Radxa Zero 3W and 3E:https://radxa.com/products/zeros/zero3w/ https://radxa.com/products/zeros/zero3e/ Prints in 3 parts (top middle and bottom) and 4 legs that slide into the bottom piece (this decision was made to make the bottom face print smoothly from the bed) The GPIO is exposed for easy prototyping work with it. It has been carefully designed to be assembled without any screws or threaded inserts, optionally 2 M2.5 3mm screws and threaded inserts can be used to securely mount the board The top piece is somewhat loose but I think it's fine so long as you are not violently shaking it This case is also compatible with the 3E version's ethernet port however I do not have one to test out its success of fitting. 30mmx30mm 5V DC fan cannot be fitted within but it can be placed above the top piece for sufficient ventilation if using Radxa's 5519A heatsink: https://radxa.com/products/accessories/heatsink-5519a/ S