Rage Face Filament Guide

# Boring Story Time

I built the Prusa V2 enclosure, but mounted a single spool on top as I don't have the MMU upgrade. However, I drilled the filament hole off-center... which made me rage. I thought it was fitting that I use a rage face to cover the incorrectly positioned hole. It certainly felt appropriate as I spent hours trying to work through Blender's bull ****.

## Files Present
* RageGuideBolt.stl - Short bolt, print for mounting on a hollowed out Ikea lack table. Drill hole needs to be approximately 9mm. 12mm bolt head.
* RageGuideBoltLong.stl - Long bolt, 50mm shank, print for mounting on a full thickness Ikea lack table. Drill hole needs to be approximately 9mm. 16mm bolt head.
* RageGuideTest.stl - Small test block to ensure the bolt will thread into the head using your slicer settings
* RageGuide.stl - Pissed off filament guide

### Printing

I used 5% infill for the head as this part doesn't need any strength. I used PETG and no supports to print it. I suspec