Raging Droner GP6

GoPro hero 6/7 mount for Raging Droner from 20 to 45 degree. No props in view.
The earlier version has been upgraded to prevent jello.
Use D40 TPU or something stiffer
Print profilv5 with infil 20% or less. It does not matter
Connector have to be printed with 90-100% infil. GoPro case same as connector.
If you have problem with fixing connector with GP mount just cut some piece from mount. Project have 0,6 mm clearance so it depends on print how tight it will be, but I do not think it matters. After all its rubber.

In the future, I'll do some mounts that will protect the cameras more.
I am currently flying at 30 degrees and after several PID changes I am satisfied.

Use D40 TPU or something stiffer.

Have fun !