Railcore Webcam Mount

Mount for a modified Logitech webcam; Attaches to 1515 aluminum extrusion in a corner.

I designed it for my Railcore printer.

Requires captive nuts in the frame.

I designed this for an older Logitech webCam with the base removed, I don't have a model number anymore, but It looks like there are a few models over the years with a similar design that should work, as long as they didn't change the design too much.

I included a mirrored versions, to mount on front left or front right.

The hole for the camera has flat side so make sure you rotate it right. If you want to put the screw back in the camera to hold it in it's new base you should be able to go right through the one layer of plastic; I left my screw out though as it is easier to remove as needed.