Raise3D Filament Runout Sensor
door Firesped
81
Downloads
51
Likes
0
Makes
Filament Runout Sensor part for Raise3D N-series printers.
This part is designed to use the N-series endstop to create a sensor to detect when filament has runout.
You will need the following for this.
1 or 2 of this endstop from raise3d depending on how many sensors you want to make
https://www.raise3d.com/collections/accessories/products/copy-of-n-series-spare-parts-hot-end-assembly-v2
for each sensor you need
1x Raise3D endstop
2x M6x7mm 8mm OD Knurled Threaded Insert
2x PC4-M6 Push-In Fittings
Each sensor will also need a cable that needs
2x JST-XHP 2 pin male plugs and matching pins.
2x wires to run from the sensor to the RUMBA board,
wiring and connectors to connect the endstops to the motion controller board.
to note: I listed as no derivatives because changes to the design could lead to it not functioning properly. If you wish to use alternate push-in fittings and threaded inserts, I will make versions for that.
further note: image is of a produ
This part is designed to use the N-series endstop to create a sensor to detect when filament has runout.
You will need the following for this.
1 or 2 of this endstop from raise3d depending on how many sensors you want to make
https://www.raise3d.com/collections/accessories/products/copy-of-n-series-spare-parts-hot-end-assembly-v2
for each sensor you need
1x Raise3D endstop
2x M6x7mm 8mm OD Knurled Threaded Insert
2x PC4-M6 Push-In Fittings
Each sensor will also need a cable that needs
2x JST-XHP 2 pin male plugs and matching pins.
2x wires to run from the sensor to the RUMBA board,
wiring and connectors to connect the endstops to the motion controller board.
to note: I listed as no derivatives because changes to the design could lead to it not functioning properly. If you wish to use alternate push-in fittings and threaded inserts, I will make versions for that.
further note: image is of a produ
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!