Thingiverse
Raise3D N2 Camera Mount
von basilfawlty
22
Downloads
14
Likes
1
Makes
This is a mount for webcams, ip cameras, Go-Pros, or any other cameras that will accommodate a standard 1/4" camera mount. It snaps on without tools and is easily removable. Access is from the top of the printer.
The Microsoft Lifecam I'm using has a usb cord long enough to run along the top of the printer, down the channel in the right-rear, and out the bottom for easy connectivity.
Future plans include a version that can handle a pan/tilt ip camera.
I printed this on a Raise3D N2+ using ABS+ on a glass bed with BuildTac.
Fill: 60%
Shells: 3
Rafts: None
Support: All
Everything else was set to the ideaMaker ABS default.
The Microsoft Lifecam I'm using has a usb cord long enough to run along the top of the printer, down the channel in the right-rear, and out the bottom for easy connectivity.
Future plans include a version that can handle a pan/tilt ip camera.
I printed this on a Raise3D N2+ using ABS+ on a glass bed with BuildTac.
Fill: 60%
Shells: 3
Rafts: None
Support: All
Everything else was set to the ideaMaker ABS default.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!