Raise3D N2 Lid Extender

Print four of these and place one in each corner of the machine to increase the lid height by 100mm. This stops the plastic filament tube rubbing the inside of the lid and prevents scratching. Plus I don't have to prop the lid up or put it on my floor when not in use. Fit on the machine side is snug by design - mine needed a firm push to seat. The flat base should touch the upper face of the machine and the lip will clear by 1mm. I also added a blob of hot glue to make sure they don't move. Fit on the lid side is very loose so it's easy to fit the cover.

Recesses in the printed parts mean you can add sheet material to make a complete enclosure if you want to run ABS, etc. Most sheet material would probably work as long as it's under 4.65mm thick. Exact measurements (you decide on tolerance) for the side panels are:

- 2 off @ 576.7mm wide x 105mm high
- 2 off @ 544.7mm wide x 105mm high