Thingiverse
Raise3D N2 Part Fan Bracket
por abedolinger
31
Descargas
18
Likes
0
Makes
Remix of Anubis123's remix of Firesped's blower fan duct. I made the following changes:
- Split into two parts to minimize supports
- Strengthened the fan mount arms
- Removed the wall of the duct on the nozzle side, so more air gets pushed there. I found that the last version wasn't as direct as I wanted
- Tailored the extruder mount to slip into the extruder's front bolts
Required parts:
50mmx15mm blower fan
4x M3x16mm bolts
2x M4x16mm bolts
Print with ABS or other temp-resistant material.
Thanks very much to the original creators, hope you can get some use out of this!
- Split into two parts to minimize supports
- Strengthened the fan mount arms
- Removed the wall of the duct on the nozzle side, so more air gets pushed there. I found that the last version wasn't as direct as I wanted
- Tailored the extruder mount to slip into the extruder's front bolts
Required parts:
50mmx15mm blower fan
4x M3x16mm bolts
2x M4x16mm bolts
Print with ABS or other temp-resistant material.
Thanks very much to the original creators, hope you can get some use out of this!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
