Slicer Discord
RAK WisBlock  – 3D-Druckmodell von Thingiverse Thingiverse

RAK WisBlock

0 Downloads
1 Likes
0 Makes
Zum Modell
There are a lot of smaller setups, but i wanted something with alot bigger battery and solar. I have just been playing with this setup with meshtastic and will potentially in the future make it so it can attach to a collar and go on cattle.

RAK WisBlock 19003 Base
RAK12500 GNSS GPS Location Module + Antenna
5V 200MA Solar Cells
1.25 mm JST 2 Pin Micro Electrical Male and Female Connector Plug
5200mAh 3.7v Lithium ion Battery with 2.0Pin JST-PH JST 2.0/2P Plug
2.0MM Heat Sets
M2*6MM Screws
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen