Thingiverse

RamboPi

von Darklotus

56 Downloads

28 Likes

0 Makes

Update 04/22/2020

Added STL file RAMBoPi v3_Prusa.stl

I've had multiple requests to trim the mounting tabs so the base can be printed on a Prusa. As requested here is the base with the mounting tabs trimmed 3.5mm on both sides.

Update 06/23/2018

Added a CR-10 3D printer cover. This worked so well on my MPCNC, I decided to make one for my printer. After many hours of use, the cooling of this enclosure works very well. Couple of days it was in the upper 90's in my shop and the enclosure never got above 80.

Update 04/02/2018

Added pictures of the installation.

Update: 03/29/2018

Well, I'm on my third revision of this enclosure. I printed V1 while I was waiting for my RAMBo to come in. Once installed, I noticed a few things I did not like. This current revision offers much better air flow, wire management, and better standoffs. I also didn't want another USB cable going to the enclosure to power the Pi. There are multiple ways to power the Pi, either use the aux 5v

CR-10 CR10 Creality Creality CR-10 enclosure MPCNC Rambo rambo board Rambo Case Raspberry Pi raspberry pi case CR-10 CR10 Creality Creality CR-10 enclosure MPCNC Rambo rambo board Rambo Case Raspberry Pi raspberry pi case

Quelle

Thingiverse

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker

FDM / FFF

Dateiformat