Ramlethal Sword // Guilty Gear Strive

This replica of Ramlethal Valentine's sword from Guilty Gear Strive is the first model I ever made on 3D modeling software. Despite being made over 2 years ago, I've only decided to put it up for people to print now because I finally was able to print it in multiple colors. The picture of the three swords has the first one I ever printed (top), my old keychain (middle), and my new keychain (bottom). While the first two were completely hand painted, the third uses black, white, and green PLA for a nicer finish. Its small, and it's not perfect, but this model holds a special place in my heart. Included in the profile are four different ways to print the sword. If you want to print it as one piece, it is HIGHLY recommended that you use support filament. I cannot stress how much of a difference it makes for the quality. Since almost the entire top part is supported, the support filament really works wonders in providing a clean finish. If you don't own any of this, (I don&#