Ramps Enclosure

**RAMPS Enclosure Rev 1.0**
A simple enclosure for the RAMPS 1.4. For the fan sizing (and quiet operation) I'm using the Noctua NF-A4x20 but any similar sized fan should work...

Walls are 3mm to give more strength when printed with PLA... Print time is approximately 7 hours @ 0.3mm layer height...

I choose not to use the green quick connect plug as it forces you to recess the PCB to such an extent it makes connecting the USB very difficult, besides, it's only rated for 10 Amps and my printer (and many others) requires ~13 amps or more...

I haven't added any fastening method yet... can't decide on one...

The *ramps_pcb_approx.stl* file, is a very close approximation of the ramps combo and might be of interest to someone so I added it above...