Thingiverse
Ramps-pi-Display modular case
por goroph1
1
Descargas
0
Likes
0
Makes
I found several of the other cases ether didn't support all the following:
Pi
Arduino
Ramps board
Full Display
or they were just to crowded, hard to mount the boards, and hard to wire up. Many of the designs also required a bit of supports. Every side of this case is removable. It set up to print every piece without supports.It isn't that hard to assemble, but there are a lot of screws that are required. Feel free to tweak the design as needed. The foot is scaled for a US 8/32 nut (sorry all you metric lovers out there, It is what I had on hand)
Pi
Arduino
Ramps board
Full Display
or they were just to crowded, hard to mount the boards, and hard to wire up. Many of the designs also required a bit of supports. Every side of this case is removable. It set up to print every piece without supports.It isn't that hard to assemble, but there are a lot of screws that are required. Feel free to tweak the design as needed. The foot is scaled for a US 8/32 nut (sorry all you metric lovers out there, It is what I had on hand)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!