Thingiverse
Range Bag Battery Case
por Pattersaurus
3
Descargas
16
Likes
0
Makes
A compact, durable, water-resistant battery case for your range bag. Might even be waterproof, but I haven't tested that.
Carries the following Batteries:
4x CR123
4x CR2032
3x CR1620
3x AAA
Requires four 1/16"x1" Stainless Steel pins. These can be found on many online retailers.
Recommendations:
ABS for the BODY, LID, and LATCH. 20% Infill and 6 wall loops for strength. Support and a brim to prevent corner lifting. Print the latch vertically, lengthwise on the z axis and print with tree supports on build-plate only. I did not need to use a drill on the hinges, but I did need to use a 1/16 drill bit on the latch after printing. I found it easiest to press the pins in on the edge of a workbench table. A vice is helpful as well.
TPU for the GASKET and ANTI-RATTLE INSERT. Gasket at 100% infill, but print the anti-rattle insert with gyroscopic infill at 10%.
Carries the following Batteries:
4x CR123
4x CR2032
3x CR1620
3x AAA
Requires four 1/16"x1" Stainless Steel pins. These can be found on many online retailers.
Recommendations:
ABS for the BODY, LID, and LATCH. 20% Infill and 6 wall loops for strength. Support and a brim to prevent corner lifting. Print the latch vertically, lengthwise on the z axis and print with tree supports on build-plate only. I did not need to use a drill on the hinges, but I did need to use a 1/16 drill bit on the latch after printing. I found it easiest to press the pins in on the edge of a workbench table. A vice is helpful as well.
TPU for the GASKET and ANTI-RATTLE INSERT. Gasket at 100% infill, but print the anti-rattle insert with gyroscopic infill at 10%.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!