Raspberry 3 UMPC 4"

My first attempt to make Raspberry Pi UMPC. I designed the case as small as possible, but screwed with M3 screws to be reliably held together. Project also contains stylish cover to protect the touchscreen when not used.

Parts needed:

* Raspberry 3B / 3B+
* Waveshare LCD 4" GPIO
* Printed case
* 4 x M3x30 screws + 4x nuts to screw the case together
* 4x M2.5x5 screws to screw Raspberry in place

Print all parts on their most flat surfaces. Use supports, there are a few needed only and usually are easy to remove after the print.

Important: print the cover vertically, standing on its shorter edge. This is required for the hinge to be durable enough.

Note, that this will give you usable computer, but not practical. Screen is cool, because connects only via GPIO pins, but the SPI connection gives you ~5FPS (so no video, no games etc.). Console works very well though.