Raspberry Camera Lisiparoi Mount

I liked https://www.thingiverse.com/thing:2113975 but wanted to use a Lisiparoi LED ring to shed some light on my prints. So I redesigned the camera case. You can use it directly on thing 2113975 or you can remove the three arms and connect you own adapter. Print with 0.2mm layer height is possible.

UPDATE: In certain settings the space for the connector to the Lisiparoi proved to be a little too small. Together with vibrations during a print, the back would fall off. In V2 the space for the connector is a bit larger. The back has a higher rim to make more contact with the front. After two tweeks of testing this version, it didn't fall off. Yet :)

FREE BONUS! :) I've added a cable clip to keep the camera and Lisiparoi cable together. Before use, first bend the clip along the two thin parts. Squeeze the bends, with your fingers, hard. Insert the Lisiparoi cable, followed by the camera cable. Bend over the part with the hole, then the part with the cylinder. Finally, push the cylin