Thingiverse
Raspberry Camera Mount Cap
by Sybergeek
5
Downloads
2
Likes
0
Makes
Modification
============
https://www.thingiverse.com/thing:3809015 the basis of this component. The camera PCB slips into the mount, but the PCB is not stationary. This cap slips over the mount and prevents the PCB from moving or being snagged while working around the printer.
Origin
======
https://www.thingiverse.com/thing:4441076 presented a thumb screw to replace the wing nut on the front-left corner of the BIBO bed. It is too wide for the other two positions.
I have created a smaller version to fit the right-front corner and the back-center.
A M3-.50 nut is required.
============
https://www.thingiverse.com/thing:3809015 the basis of this component. The camera PCB slips into the mount, but the PCB is not stationary. This cap slips over the mount and prevents the PCB from moving or being snagged while working around the printer.
Origin
======
https://www.thingiverse.com/thing:4441076 presented a thumb screw to replace the wing nut on the front-left corner of the BIBO bed. It is too wide for the other two positions.
I have created a smaller version to fit the right-front corner and the back-center.
A M3-.50 nut is required.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!