Thingiverse
Raspberry camera support for Geeetech Prusa i3 pro b
von Dosclic98
16
Downloads
6
Likes
0
Makes
You will need
2 x M5x20 mm screws (GoPro screws are fine as well)
2 x M5 bolts (also the GoPro one are fine)
4 x M2x10 mm screws to tight the camera with the front part (also 2 are enough)
I created this pieces to let me put my Raspberry IR camera in the position i wanted near my raspberry pi 3B+. The Round_Joint is round to fit in the support piece so you can regulate the direction you want to point the view, using the other junctions you can tilt the camera up and down.
You might need a bit of sanding in the support dovetail depending on your printer precision.
2 x M5x20 mm screws (GoPro screws are fine as well)
2 x M5 bolts (also the GoPro one are fine)
4 x M2x10 mm screws to tight the camera with the front part (also 2 are enough)
I created this pieces to let me put my Raspberry IR camera in the position i wanted near my raspberry pi 3B+. The Round_Joint is round to fit in the support piece so you can regulate the direction you want to point the view, using the other junctions you can tilt the camera up and down.
You might need a bit of sanding in the support dovetail depending on your printer precision.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
