Thingiverse
Raspberry lateral holder plate
von Fred-D
2
Downloads
0
Likes
0
Makes
Hi!
As I completed my Octoprint setup, it was time to clean up around the printer ;0)
I designed this lateral holder plate for the following Raspberry Pi case :
https://www.amazon.fr/Smraza-Alimentation-Interrupteur-Dissipateurs-Ventilateur/dp/B01M3QWZE7/ref=sr_1_33?__mk_fr_FR=%C3%85M%C3%85%C5%BD%C3%95%C3%91&dchild=1&keywords=pi+case&qid=1590420637&sr=8-33
Nothing special about it, except it's respecting the cooling clearance around the case.
You just need to print it and fix it with some double tape and that's it!
My advice about it : Even if it's easier to print it flat (as I did), avoid it if you want to get a really sturdy print. Just my two cents.
Enjoy!
As I completed my Octoprint setup, it was time to clean up around the printer ;0)
I designed this lateral holder plate for the following Raspberry Pi case :
https://www.amazon.fr/Smraza-Alimentation-Interrupteur-Dissipateurs-Ventilateur/dp/B01M3QWZE7/ref=sr_1_33?__mk_fr_FR=%C3%85M%C3%85%C5%BD%C3%95%C3%91&dchild=1&keywords=pi+case&qid=1590420637&sr=8-33
Nothing special about it, except it's respecting the cooling clearance around the case.
You just need to print it and fix it with some double tape and that's it!
My advice about it : Even if it's easier to print it flat (as I did), avoid it if you want to get a really sturdy print. Just my two cents.
Enjoy!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
