Raspberry Pi 0w Enviro Case (Pi Zero)

Wanted to mount my Pi Zero W with Pimoroni Enviro (link below) inside my sealed filament box. Remixed the reference geometry and added tabs to mount with VHB tape on the inside of the box. 4 M2x12 hold the assembly together.

I'm using a IP67 rated tub from target to hold my filament. I am working on a pass through for the box, but currently the setup is running standalone on a 20,000mah battery pack (lasts about 100 hours on a full charge)


https://shop.pimoroni.com/products/enviro?variant=31155658489939
(Setup is complicated on RPiOS Legacy Bullseye, you need to roll back st7735 to version 0.0.5 or the screen doesn't work)

Fusion360 did not like one of the reference files so you may need to scale by 10.