Raspberry PI 2 multi-sides fixture

You have a Raspberry Pi 2 to fix in your product case ?
- when you have to fix it flat, no problem ... just 4 spacers+4 screws et voila !
- but when it comes to fix it on one side/edge ... more complex ; this is where this fixture is handy

it permits to fix it in your product box on any of 3 sides, either over the board as Under the board, with plenty of locations for srews or nuts.

TIP: if you need it as light as possible (FPV or others): choose the side you need, then at slice time, place this one down on the plate (z=0) and during printing or during the slicer setting, stop the printing 10mm before the end

Here printed with "Thingiverse Blue" :)
There is a logo, but inside & not visible when board is in place.